whitakercormier870448

Fiat 500 Replacement Key Fob

If your remote key fob isn't working, it's time to replace the battery. However, if you replace the battery and it continues to stop working the issue is probably elsewhere.

United Locksmith specializes in the creation of new keys for classic automobiles. We have all of the tools and parts necessary for this service.

Dead Coin Battery

The most frequent reason that your Fiat 500 key fob will not unlock or lock the doors is due to a dead battery. The key fob is equipped with a coin cell battery which will quickly drain when it isn't being utilized frequently enough. If your remote starts to show signs of a loss of range or has stopped functioning and the battery is not working, it could be dead.

The battery in the key fob is held in place with metal clips for retaining. If the clips aren't tight enough, they can cause contact issues which will prevent the remote from receiving power. Use a flathead screwdriver to break open the retaining clip and remove the battery. Make sure to use a battery with the same voltage, size and specifications as the original.

Water exposure can also cause the key fob to corrode or become damaged. Even a small bath in soapy water may harm the electronic chip within. Keep your key fob dry.

Water Damage

If your key fob doesn't work correctly, it could be caused by water damage. Key fobs are fitted with rubber seals to protect them from being damaged by a light rain or splashes of water, however it is essential to keep your keys from being tossed into the ocean, pool, and the washing machine!

The key fob is equipped with an electronic chip that transmits a signal to your car's immobilizer system. This is the reason why your 500 can lock or start, but in the event that the chip becomes wet, it's unable to longer work.

If you want to check if your key fob is functional You can clean the internal electronics with isopropyl or an electronic cleaner. However, https://www.g28carkeys.co.uk/fiat-car-key-replacements-near-me/ is probably best to get a replacement from a dealership rather than trying to fix the key fob which is submerged in salt water.

A replacement fob can cost you some money but it's far less expensive than paying to have your Fiat 500 towed to a dealer and repaired there! You can also do it yourself by following only a few steps. Just ensure you have the right battery type before you attempt to open your key fob. This is a job that's far simpler than it appears, and there are step-by-step instructions online for almost any key fob in your car.

Faulty Chip

The chip in the key fob communicates directly with the immobiliser on your car to ensure that the vehicle will only start when proper keys are inserted. If the chip is damaged or destroyed the car will not start no matter what you do.

A faulty chip can occur due to a variety of reasons, but the most common cause is water damage or the battery being dead. It is recommended to leave the job to a professional locksmith, who can replace the chip in a short time and at a a reasonable price.

If your key fob will not work after being exposed to clean tap or rain water take it off the battery. Wipe down the electronic component with paper towels. If the key fob still isn't working it's probably to be a damaged chip and is required to be replaced.

A few people turn to their dealer when they are in need of an entirely new Fiat key fob, however this is a expensive option. United Locksmith is the best option for you if need your Fiat keyfob repaired at a reasonable price. We have all the tools and knowledge required to fix your Fiat fob in a timely and professional manner.

Faulty Receiver Module

Fiat key fobs transmit signals of up to 50 feet to the vehicle, which can unlock and close the doors (and start the vehicle for vehicles with automatic transmissions). There are a variety of reasons why the fob could stop working. It could be due to a dead battery or water damage, worn buttons, a receiver module issue and signal interference or an electronic chip that has failed.

img width="350" src="">
If the fob is stored in a place that has suffered a severe trauma, such as being dropped on hard floors or being washed in a washing machine and it isn't capable of communicating with the car's Body Control Module (BCM). This is because the BCM is a secure system that can only accept a signal from a genuine original key, and not from any other.

If this is the case, then you must replace your fob. A professional locksmith is able to handle every aspect of the key replacement procedure as well as programming a new one for the 500. They can even give you a clone fob that works just like the original (and costs just a fraction of the cost).