![[PukiWiki]](image/pukiwiki.png "[PukiWiki]")
|
Sliding Patio Door Repairs
Fortunately, most of these issues can be fixed with a bit of DIY expertise. Here are some common problems and solutions: Dirty or Damaged Tracks Over time the sliding patio door's tracks may be clogged with dirt, dust and other debris. Regular cleaning and lubrication can aid your sliding patio door to move smoothly. A dirty track can cause the door to become stuck or make it difficult to close or open, so the first thing you need to clean it. Begin by removing any debris that has fallen off using a Broom. Use a brush that contains the cleaning solution to eliminate any visible grime. Make sure you clean all the nooks and corners, as well as the areas where the door joins its frame. After you've scrubbed it, rinse the track using a hose or bucket of clean water. Apply an oil that you can buy from the store to remove moisture and stop future corrosion. Before you reinstall the door check it by sliding it back and forth to see whether it moves easily. If your door continues to stick, it could be that the rollers have been damaged or misaligned. This can cause the door to become stuck. In most cases, you can resolve this by adjusting the wheels and then lubricating them. If your door is old, it could be the right time to consider a new replacement. Before reassembling the track, lay a drop cloth on the floor and take off the two plugs covering the screws that adjust the rollers on the bottom of the frame. Put a screwdriver into each hole and turn them counterclockwise to retract the rollers. This will give you enough room to remove the door from the sawhorses, and place it on the sawhorses. In time the handle on your sliding door may become loose from the strike plate it is mounted on. The good thing is that a loose handle can be fixed easily. Simply use a screwdriver tighten the screws that attach the door handle to the strike plate. Be cautious not to tighten too much, as this can cause damage to the mechanism inside, and cause the handle to not function correctly. The problem of a sliding patio door that isn't easy to slide is typically caused by debris that blocks the rollers. Dirt, dust, hair and fur often get into the tracks, causing the door to not slide smoothly. To promote smooth operation, start by cleaning the rollers. Another common issue is that the lock on your sliding patio door isn't working properly. This could be caused by a misaligned or broken handle. The lock mechanism could be replaced or the handle adjusted. A screen door that doesn't close or unlock isn't a pleasant experience. A faulty screen can be dangerous. If the screen isn't aligned properly with the door frame it will rub against the frames and cause wear and tear to both the screen and door. The solution to screen that isn't working properly is pretty simple. Check that the latching bar is still in place. If it is not in place, take it out of the way it and replace with a replacement. Once you've replaced the rod that latches, put it back on the screen and ensure that the hinges are properly set. For a finished look, add screw covers to the holes in the frame. Poor weatherstripping The weather stripping is used to seal the gap between your door and frame, preventing drafts, cold and insects. It's time to replace it if it's damaged, cracked or hardened. It's generally fairly simple to do. Some people only replace the worn part, but it is more straightforward to replace the entire thing. First, make sure that the gap isn't near the seat point at which the weather strip is placed on the frame. If not, you'll need to seal the weather strip to the frame using weather strip adhesive. Then, look around the area around your weather strip. Examine for a tear rip or crack which could be allowing cold air in. Then, use your dollar bill to test whether the weather strip is sealed with a positive seal. Simply place the bill half towards the seal and close the door to see whether it pulls away from the flange of metal of the weather strip. If it is easy to remove, it's time to replace the weather strip. You may also need to lubricate the run channel (the groove of felt and rubber that runs vertically along both sides of your door) to prevent the build-up of ice in winter. You can buy a spray lubricant from your local hardware store. Be careful not to get it on the glass. Another option is to spread a thin layer of sand underneath your door before the snow starts falling and prevent it from sticking as salt would. Be careful not to leave any sand on the floor of the door, however it could cause damage to the rubber and concrete of the weather strip in the course of time. Damaged Glass There are many situations that can lead to the glass of a sliding patio door breaking or cracking. If it's caused by a knock or a bump, if the glass on your patio door is damaged, it is important to replace it as soon as possible to ensure that your home is sealed and well-insulated. Over time, sliding doors are susceptible to damage because of regular use and exposure to the elements. The rusting of the rollers, broken handles and bent tracks are just some of the issues that can result in the patio door not working correctly. Repair experts for sliding patio doors are able to pinpoint the cause of the problem and fix any issues or replacements. A broken patio door can impact your energy costs in addition to the obvious damage. A gap between the frame of the patio door and the glass could cause drafts and temperature differences. This is costly in both the winter and summer seasons when you have to pay to cool or heat your home. You can fix a damaged panel on your patio without having to remove the whole door. This is the ideal option in certain circumstances if you need to get your sliding patio door back up and running quickly. No matter if you are replacing the glass or just the frame, it is crucial to have all the necessary tools available to ensure the task can be done safely and efficiently. This includes gloves, a small pry bar or hammer, putty knife, tape measuring tape, and a glass replacement. DIY Door Store offers all these items to help you repair your damaged sliding patio doors easily and cheaply. Frames that are damaged or loose. Sliding patio doors are designed to simplify access from indoors to outdoors and allow for natural flow of traffic. As with any home appliance sliding patio doors are susceptible to wear and tear that may hinder their function. Certain damages are simple to fix, while others require expert assistance to keep your door in good condition. If you can see signs of damage, like dents and scratches, it's probably time to replace your sliding door. These damages impact the security and energy efficiency of your patio door, as well as its appearance. A roller or track that is not aligned is common problems that cause your sliding door to not function correctly. This is often due to debris or dirt accumulation on the track and is typically fixed by using pliers to straighten out the rails. It is essential to clean the rollers and tracks of your sliding patio doors, as dirt can lead to rigid or sticky doors that don't move smoothly. Using a hand brush or vacuum, or spray-down using a jet wash can assist in clearing any obstructive build-up. The addition of a silicone-based lubricant your tracks can also aid in smooth operation and protect against premature wear. Over time, slamming your patio door can cause serious damage to both the frame and the glass panel. This can lead to broken or loose frames or tracks that are bent, as well as a handles that are difficult to open and close. Screen door frames that slide tend to be less durable than glass sliding doors, making them more susceptible to damage. If you've damaged your screen door frame it can be fixed by resealing with silicone lubricant, then applying new sealant to the glass's perimeter. |
