nievesdonovan990991

Peugeot 308 Key Fob Problems and How to Fix Them

If your Peugeot 308 key fob has stopped functioning one day it could be due to a dead battery in the coin or water damage and receiver module issues or a damaged electronic chip. These are all easy solutions that will bring your car back to speed in no time!

Car keys can also become faulty because the key blade gets worn. You can easily fix this issue by visiting your local Car Key Man Auto Locksmith to get a new blade installed.

Battery

The key fob battery in your Peugeot 308 can sometimes die or become weak enough to send an effective signal to the car. The key fob can not function and stop you from locking or unlocking your doors, or even starting the engine. You'll need a new battery for your key fob to repair this.

You'll need to purchase batteries for replacement from an auto parts shop or your local hardware store. Make sure that the battery is brand new and not sat on the shelf for too long. A fresh new battery will have greater capacity and can send a stronger signal to the car.

After replacing the battery, try unlocking the doors and locking them with the key fob. If the doors don't open it's likely that the receiver module in the car is the culprit. The local Peugeot dealer can reprogram the receiver module.

The internal chip of the key fob might be damaged. This could happen when you drop your key fob on the ground or expose it to water. The rubber seals that protect the chip from moisture might get worn out over time, particularly if your key fob is exposed to water for long durations, like submerging it in the ocean at the beach. To avoid this from happening, it's important to protect your key fob from water and never let it come in contact with water.

Water Damage

If your key fob gets soaked, whether you dropped it into the pool or threw it into a puddle, don't think it's a loss. The key fob is protected by rubber seals but prolonged exposure to water could damage its electronic chip. Since water is a good conductor so any water that makes it inside the key fob will create a series of short circuits, which could eventually destroy the chip. After removing the batteries, clean the contacts using isopropyl and dry them completely before putting them back in.

Your Peugeot 308 may not start because of a dead battery. If you have a spare car, jumper cables could be used to start the engine again. If the battery is faulty it is required to replace it.

A malfunctioning receiver in the car may also hinder it from receiving the signal from the keyfob. The key fob may be damaged or there could be an issue with the antenna, wiring, or the key fob itself. If you are using an entirely new key fob, it may need to be programmed for the vehicle. If you're unable to solve the issue yourself seek out a professional technician. A trained technician in the field will be able identify the issue quickly, and then fix it right away.

Radio Interference

For example, a key fobs not being recognized or having a narrow range usually indicate that there is a problem in the system. https://www.thekeylab.co.uk/peugeot-car-keys/ could be transmitted or radiated, the latter caused by power and speaker cables that are too close to electrical parts. In general, rerouting cables or moving them away from these components will resolve the issue.

It's unlikely that someone is listening in on your key fob signals to steal your car, however it's possible that the signal is being distorted by radio frequency interference. Luckily, this is a simple issue to repair.

If you are having keys that are not recognized, try using an entirely new battery. Also, make sure that the battery is of the right size and type. Batteries that aren't the correct size can cause damage to your device.

Some aftermarket alarm systems and radar detectors use the same radio frequency as your key fob, and could cause them to interfere with your key signals. It is recommended to avoid having these devices attached to your key fob.

img width="340" src="">

Pairing Issues

The remote keyless entry system contains an antenna that receives radio frequency signals from the key fob. It will not be possible to start your car if this receiver is malfunctioning even if the key fob is working and is reprogrammable. The issue could be caused by a range of causes, including the battery of a coin that is dead and water damage. The receiver could also be malfunctioning because of a software bug or internal damage to the key.

One of the most common reasons for why your Peugeot 308 key fob is not working is that the battery inside has died. You can easily replace this with a new battery, but it is important to select the correct battery for your key fob. If you use a battery that is not correct, it could lead to further problems with the key fob, therefore it is best to choose the original battery or the replacement that is identical in size, voltage, and specifications.

Your Peugeot 308 keyfob may not work if it has been associated with another vehicle. This could happen if you have given your key fob to someone else or when the key has been used to unlock and start other vehicles. You can resolve this by reprogramming the key fob with an OBDII scanner. The scanner will usually ask you for specific information about your vehicle, for example the VIN or engine type, so it is essential to enter this information correctly.