godfreyeaton540306

Fiat 500 Replacement Key Fob

If your 500 remote key fob has stopped working, it's time to replace the battery. If you replace the battery and it still doesn't work it could be a problem elsewhere.

At United Locksmith, we specialize in making new keys for old cars. We have all the tools and components needed to perform this service.

Dead Coin Battery

A dead battery is the most common cause of your Fiat 500 keyfob not locking or unlocking the doors. The key fob is equipped with the battery of a coin-cell that will drain quickly when it isn't being utilized frequently enough. If your remote began to show signs of weakness like a loss of range or stopped working completely The battery is probably dead.

Metal clips hold the battery in within the key fob. If the clips aren't secure, it could lead to problems with contact, which can prevent the remote from receiving power. By using a small flathead screwdriver, pull the retaining clip outwards to take out the battery and replace it with a new one. Choose a battery that is the same size, voltage and specification as the original.

Water exposure can cause the key fob to become corroded or damaged. Even a short bath in soapy water could harm the electronic chip in. Keep your key fob dry.

Water Damage

If your key fob doesn't work properly, it could be caused by water damage. Key fobs are fitted with rubber seals to protect them from being damaged by rain or a splash of water, but it is very important to keep your car keys away from the pool, ocean, and washing machine!

The key fob has an electronic chip that sends a signal car's immobilizer system. The chip allows the 500 to lock and start. If it gets wet, it will no longer function.

If you want to check whether your key fob still working, you can clean the internal electronics using isopropyl or electronic cleaner. However, it's better to purchase a replacement from a dealer instead of trying to fix a key fob that is submerged in salt water.

Although a replacement fob may cost a bit of money, it's a lot cheaper than paying for your Fiat 500 to be towed to the dealership and repaired! Plus, you can do it yourself in several easy steps. Be sure to have the correct battery type before attempting to open your key fob. There are step-by-step directions for any key fob in your car online.

Faulty Chip

The chip inside the key fob is in direct communication with the immobiliser on your vehicle to ensure that the vehicle will only start when correct keys are used. If the chip is damaged or corrupted in any way the car won't start.

A faulty chip can occur due to several reasons, but the most common cause is water damage or the battery being dead. Whatever the reason, it's best to delegate the work to a locksmith as they will be able to repair the chip for you swiftly and at a reasonable cost.

If your key fob stops working after exposure to clean tap water or rain, remove the battery and wipe down the electronic component using a paper towel to ensure it's dry before putting it back in. If the key fob fails to work it's likely to be a fried chip and is required to be replaced.

A few people will visit their dealer if they need a new Fiat fob. But, this can be expensive. If you are seeking a cost-effective solution to get your Fiat key fob fixed Look no further than United Locksmith. https://www.g28carkeys.co.uk/fiat-car-key-replacements-near-me/ have the tools and expertise necessary to repair your Fiat key fob in a quick and professional way.

img width="489" src="">

Faulty Receiver Module

Fiat key fobs transmit a signal to the vehicle, which will unlock and close doors (and start the car for those with an automatic transmission) up to 50 feet. However, there are several things that can cause the fob to cease working. This includes a dead coin-battery water damage, worn-out buttons an issue with the receiver, signal interference, or malfunctioning chips.

If the fob has been in a pocket that has endured extreme trauma, like being dropped on a hard floor or getting washed in a washer and it isn't able to communicate with the car's Body Control Module (BCM). The BCM is a security device that only accepts signals from genuine original keys.

If this is the case, you must replace your fob. A professional locksmith is able to handle all aspects of the replacement procedure and can even program a brand new one for your 500. They can even offer a clone fob that works the same as the original (and costs just a fraction of the cost).