Peugeot 308 Key Fob Replacement

Peugeot's 308 might be getting on a bit, but it still feels appealing. It's not the most luxurious car in its class, but it's an enjoyable and comfortable drive.

Here at Coded Car Keys we are often asked to replace peugeot 308 key fobs. Whether the problem is constant or intermittent the following tips will assist.

Water Damage

img width="408" src="https://www.thekeylab.co.uk/wp-content/uploads/sb-instagram-feed-images/333316718_1040187280153908_6689347231067565339_nlow.jpg">

If you accidentally drop your key fob in an eddy, or it is soaked while kayaking, canoeing or rafting or canyoning, the fob is likely to be damaged by water. Keep your key fob in a dry bag whenever you are outdoors or engage in things that expose it to excessive water.

It is also important to make sure that the fob is completely dry prior to opening it and reusing it. If you detect any smells coming from the fob, such as an industrial-type liquid smell or that of windshield washer fluid, it's another indication that it's submerged in water.

A wet circuit board can cause the battery to discharge its charge or even explode. If you're able to fish your 308 key fob out from the body of water it got stuck in, flip the button side down and shake out as much water as possible before opening the case. Once you have opened it, remove the battery and wipe the circuit board using an abrasive soaked in 90 percent isopropyl alcohol.

Other reasons why your Peugeot 308 remote keyless entry system may not function include an empty coin battery or receiver module issue, signal interference, or an electronic chip that is damaged. If none of the above are the issue, you can reset the system by removing the 12 volt battery from your car for 15 mins.

Dead Coin Battery

Peugeot cars come with a remote-start feature that allows the driver to start the car from a distance, warming up or cooling down the car prior to entering. This feature is extremely helpful particularly during the winter's cold and chilly months. However, sometimes the remote stop system stops working due to a variety of reasons, like a dead coin battery.

A coin-shaped battery that is in the key fob will last a time of between two and four years, depending on how often utilized and where it was purchased. The date of use is usually printed on the package or in the manual.

If the key fob has stopped working after exposure to clean tap water it is recommended to remove the battery, clean the chip with a paper towel and isopropyl ethanol, then dry it completely before replacing it. If the key fob was exposed to soapy or salty water, it could have fried the chip. It is recommended to replace it.

If you are not sure the battery is defective You can test its voltage using an instrument set to the vehicle's voltage range and connected to the plus and minus terminals. If the voltage is less than 12-13 volts you need to replace the battery. You can also reset your computer in the onboard computer by disconnection and reconnecting the 12 volt batteries in reverse order. (positive cable first, then negative cable). The engine should start.

Faulty Receiver Module

If you're unable to see the "Key Detected" message on your dashboard, it's possible the receiver module has developed a fault. It's that part that sends an alarm to the car when your key fob is activated, which acts as an immobiliser and prevents it from starting until the key that you want to use is present.

It could be due to a number of reasons, such as water damage or simply getting old. If your Peugeot 308 key fob has been exposed to dirty tap water, as in the electronic chip inside may be damaged. In this case it is necessary to take the unit apart and clean it thoroughly with isopropyl or electronic cleaner. Once the battery has dried you can try it again.

If the problem persists, it's probably a good idea to seek out a local Peugeot specialist or locksmith. They can utilize a diagnostic tool in order to identify the issue and repair it.

It is stressful to lose your Peugeot car key. However, a professional auto locksmith can solve the issue in a matter of minutes. They can cut a new key and then program it into your vehicle, so you're ready to get to the road in the shortest amount of time. Click here to find a locksmith in your area.

Faulty electronic chip

The electronic chip that is in the Peugeot 308 key fob plays an essential role in the remote control system. If the chip is damaged, you may experience difficulties starting your vehicle or receive a message that says "anti-theft". If this occurs, the only way to fix the problem is to replace the key. Professional auto locksmiths are able to offer the fastest possible time.

The chip inside the key fob of your Peugeot 308 could fail due to different reasons, such as sweat, water damage or dirt. If your Peugeot 308 key fob has been exposed to soapy water, take it to the cleaners immediately. You can employ a paper towel as well as isopropyl alcohol to clean the electronic component. The battery should then be allowed to dry completely.

Sometimes https://www.thekeylab.co.uk/peugeot-car-keys/ may cease to function due to radio interference. This can be caused by other devices that operate at the same frequency as your Peugeot key fob. It can also be caused by bad weather or objects in the vicinity of the vehicle. If you experience this issue it is advised to visit the Peugeot dealership.

The Peugeot Key Fob 207/308 is very delicate and requires special attention. It is essential not to drop or throw the key fob. If you lose it, try to find it as quickly as possible. You can reset all on-board computers by disconnecting the battery that is 12 volts for a few minutes. Disconnect the negative cable before the positive.


トップ   編集 凍結 差分 バックアップ 添付 複製 名前変更 リロード   新規 一覧 単語検索 最終更新   ヘルプ   最終更新のRSS
Last-modified: 2024-04-25 (木) 09:27:28 (9d)