damsgaardmcintyre699960

Peugeot 208 Key Replacement

It is better to leave the replacement of Peugeot keys for 208 to auto locksmiths with the required equipment and expertise. They can design and program keys more quickly and at a lower cost than dealerships.

If your key fob has stopped locking or unlocking your doors it is likely due to a dead battery in the coin. There are other causes why the key may be malfunctioning.

Dead Coin Battery

A dead coin battery will prevent your Peugeot 208 from locking or unlocking, and won't start the engine. In this situation, you will need to make use of the alternative method for starting that is described in the owner's manual.

The spark plugs could also be worn out. The spark plugs light the fuel to start the engine. However they have a finite time of life. If they are not used enough, they will eventually fail.

img width="491" src="">

Fortunately, there's an easy solution to this issue. The best thing to do is to measure the voltage of your car battery with a multimeter. If the voltage falls below 11,5 volts, it's the time to replace it. It is also necessary to clean the contacts of the battery in case it is corroded. You can do this by lifting the rubber covers that protect the two terminals of the battery and using a wire brush to remove any corroded areas of the battery. Then, reconnect the cables to the positive and negative poles.

Water Damage

If your 208 does not start and the battery has not fallen flat, it is time to look at the spark plugs. You may find that they're dirty and they don't spark. This is easily fixed by cleaning the spark plugs in an workshop.

Peugeot cars are equipped with a key with a transponder compatible with the immobiliser. This ensures that only the right key is able to start the engine. If the chip inside the Peugeot key is damaged, then it won't send the proper signal to the vehicle.

Water damage is a common reason for this issue. https://www.thekeylab.co.uk/peugeot-car-keys/ is most common in colder climates. the vehicle could have been exposed to rain or snow. In this case, contact a reputable locksmith who will have the required tools and equipment to modify the key. They will also have the latest technology and machinery required to make the Peugeot smart key. The process should not take more than 15 minutes.

Contacts of the battery may be damaged.

Peugeot changed from the old carbon-encased transponder chips to a brand new type of chip that relies on electronic components that are placed on a circuit board. The new system is effective when it's brand new, but over time the circuit boards start to wear out and stop functioning correctly.

This could prevent the immobiliser from activating so your vehicle will not start. If this is the case, it's a good idea to seek out a Peugeot specialist or locksmith.

Another issue that is common is when the battery for the key fob begins to fail, which causes the key blade to stop getting into the lock. A locksmith for cars can replace the battery and cut a fresh blade for you, it's typically a quick fix.

Faulty Receiver Module

If your Peugeot key fob isn't working after dropping it on the floor, or being exposed to a sudden downpour or accidently washing it, it could be due to a faulty receiver module. The receiver is responsible for transmitting radio frequency signals to the on-board computer, which is responsible for controlling the centralized locking system of your Peugeot vehicle.

The key fob itself has rubber seals that prevent water from getting to the electronic chip inside. Water can damage the chip when exposed to the water for an extended period of time. Submerging the key fob into sea water at the beach or throwing it into the water can be particularly damaging due to the high salt content.

If your Peugeot spare key fob stops working You'll need the module replaced. This can only be done by a skilled auto locksmith or Peugeot specialist. In contrast to other vehicles, Peugeot keys are protected by a unique immobilizer system that requires the correct programming for the start of the engine. This is why you should only be able to trust a professional Peugeot locksmith with the task of designing and programming a replacement.

Computer malfunctioning on-board

The on-board computer in your Peugeot is responsible for many of the systems inside your car, from power windows to the airbags. The on-board computer will display a code if something goes wrong. This code will be stored within the system until the issue is fixed. Most often, this involves the on-board computer being replaced.

One of the main causes of the airbag light turning on is loose or corroded connectors in the airbag sensor. This could be due to wear and tear, aging, or exposure to salt and moisture. This issue should be addressed as soon you can, because an airbag that's malfunctioning could pose a risk in the event in the event of an accident.

If you see a card not found error on your Peugeot, the key battery in the key fob could be dead or weak. This prevents the key fob from sending a signal that disarms the immobilizer on your vehicle's standard. You can test this by pressing the unlock button on the key fob, then trying to start your vehicle. If this does not work it is likely that the battery must be replaced.